“Dear Levente,
This is the third time I have bought from you in 1 month and I can only say positive things!
When filling the mixer truck, we put it into the concrete through the mixer, this requires the cooperation of the mixer obviously.
Slabs were made in total of 15 cubic meters, 10 and 15cm thick, with a dosage of 2kg/cubic meter. A 2 tonne rubber tracked excavator worked on each of these areas without any problems, even though one of the areas was only 4 days old! Even the edges of the base didn’t pop off as the machine went up and down. So good product:-)”Marosi Norbert
Székesfehérvár
“Dear Levente,
Yes, I’ve used macrofiber before, but the high temperatures limited me from completing all the parts I had in mind. In the areas where I did use it, it was surprisingly easy for a first-time experience, and I dare say it turned out quite nicely. I’m thrilled to have found it and recommend it to everyone I talk to. Thank you for this fantastic opportunity! I’ll send you a picture of the final result.”
Best regards,
Zsuzsanna Aranyász
Erk
“It’s easy to use; just follow the instructions in the video you’re sent, and the result is high-quality concrete without the need for iron installation.”
Horák György
Debrecen
“When concreting a base, you don’t need to fuss with an iron mesh; you simply mix the right amount of macrofibers into the concrete, and that’s it. Unfortunately, I had to chip away a small section of the cast concrete and wait to see whether or not it was truly solid. The macrofiber did its job; it had a challenge for the chiseling machine. 🙂 I wasn’t disappointed, and I’ll order again next time because pouring concrete with this technique is faster and more cost-effective.”
Polt Balázs
Martonvásár
“It’s very easy to use, it’s also easy to spread when mixed in a concrete mixer….. A much simpler application compared to steel mesh. The company is corrrect and fast (both in information and mailing). I can only recommend it. :)”
Kresák Márk
Telekgerendás
“The Macro fibre (55 kg) arrived on time as agreed. The mixing was done by the blending plant as agreed. There were no problems with the mixing, it was much easier not to have to fumble with the mesh. It is still knitting at the moment and I am watering it diligently.”
Nagy Zoltán
Rákóczifalva
“I’ve used it twice and I’m totally satisfied with it. Cheaper, faster, better.
Regardless of the thickness of the concrete, easy to mix, greater strength.
I recommend it to everyone…. You will not regret it.”Kappel Tamás
Pécs
“Great product, glad we found it. Easy to work with, we are completely satisfied. Thank you!”
Kondert Judit
“Very easy to dose and use. We used a thinner aggregate product before the macrofiber, which had fibers protruding from the concrete. This always had to be burnt off with a gas flame after drying. With this macrofiber, because it is thicker, there was no such problem, it can be sanded perfectly.”
Bősze László
“I received the macro fibre on time, and they were used yesterday and today. The mason was initially surprised because he had been working with smaller fibers and was concerned about their workability and smoothness. Fortunately, this concern proved unnecessary; the top of the concrete could be worked nicely, and the fibers did not stick out.
Thanks for the professional service, providing really good and accurate feedback, and the prompt delivery.”
Regards,
Somkutas József
“It is quick and easy to use compared to reinforcing steel mesh. Last but not least, it costs less.”
Csabay Gyula
Rudolftelep
“Dear Levente,
It was our first time using the product as a substitute, and if it proves durable in the long run, it certainly won’t be the last. Besides being cost-effective, our primary consideration was the time and physical energy saved. With a properly sized mixing bowl placed conveniently next to the concrete mixer, it only took 3 seconds to ‘pour’ each mix. This provided me with at least a half-day’s advantage over using the concrete mixer on my garage floor.”
Tóth Bálint
Sarkad
“Hi!
We are involved in the construction of communication substructures and networks. So far, we have poured the N1 shaft, which has a surface area of about 1m³, using traditional reinforcement. We decided to try using macro fibre. The casting was perfect and incredibly robust. In fact, the manhole, weighing about 1 tonne, was lifted thoroughly with a hoist and held up. There were no cracks or breaks. In return, two people can now pour two manholes a day, compared to one with iron castings. We added 1.5-2 kg/m³.”Szabó Zoltán
Füzesgyarmat
“It’s a simple and quick-to-use material—lightweight and easy to smooth. For one-person jobs, it takes virtually no extra time to use.”
Gorzsás Tibor
Hajdúböszörmény
“The dosing of macrofiber is straightforward and flexible. For each mix, I could add the required amount based on my judgment. When smoothing the surface, minimal attention was needed to arrange the fibers. It was primarily used in small thicknesses for ‘ramming’ pavement, where traditional reinforcement wouldn’t have addressed the issue of subsequent cracking. PP fibers are the ideal solution for this task, as the random fibers bridge the subsequent load in all directions, providing strength. If I undertake any more concrete work, I’ll exclusively use this concrete reinforcement technology. While I can’t compare reinforcing steel with plastic fiber in the very long term (100 years), for 50 years, macrofiber is undoubtedly the way to go. The degradation of PP inside concrete is not significant.”
Katona Antal László
Érd
“The macro fiber was an excellent choice for the floor. It’s easy to work with and lives up to its promises. The concrete was thinner at the threshold because it needed to align with the kitchen subfloor, which was to be built later. Dealing with concrete cracking for about two weeks was challenging, but the macrofiber held up well in 3D.”
Dobos Attila
“It is significantly easier to obtain, transport and store than iron mesh.
No flexing, carrying, fitting or fiddling.
You can mix it into concrete in no time.
It doesn’t get in the way when pouring concrete.
I think it can save hours and a lot of nervousness when concreting a room base.”Dóka Anita
“I am very grateful to you for introducing this method. It is very easy to work with, and I hope the strength is adequate.”
Kazi József
“Easy to use with the calculator for precise dosing, it saved both time and money compared to using rebar. For me, it’s an excellent alternative to traditional concrete for garage doors.”
Behina Mihály
“Hello!!! The garage door is finished, and the concrete looks great!!! The owner was very pleased with both the work and the material!!! Monda is delighted that I chose this material, and I am also pleased! I would like to work with this material in the future if I have a job like this, and I would recommend it to my colleagues!!!”
Kanizsai István
Petrivente
“It makes concrete indestructible.”
Szögi Kristóf
“It’s a lot easier to work with than an iron mesh; it doesn’t require more people. That’s what I consider its main virtue.”
Hilóczki Tibor
Eger
“Dear Levente,
“We worked with it again over the weekend, constructing a light-frame house on the existing slab foundations. We strategically dowelled in several places near the edges, where the concern of potential cracks always loomed, given that iron typically fails at the edges. Working in this manner was a pleasure, as drilling too close to the edges posed no risk of mishaps.
The carpenter remarked that it felt like drilling into a homogeneous material, which was simply wonderful! He then secured the dowels in place, and they held up perfectly. This material is fantastic, and I intend to use it consistently!”
Marosi Norbert
Székesfehérvár
“As a civil engineer, I was taught that reinforced concrete is what you should always use when pouring concrete because steel is what holds concrete together. When I asked for a quote for reinforcing steel, it was just under 400,000 Ft. That’s when I discovered this plastic fiber-reinforced solution. I’ll be honest; I was very hesitant to try it. It’s new, and I was skeptical, but eventually, I dared to make the final decision.
Well, it’s good, and I’m happy with it. I saved a lot of money, and it was much easier to pour the concrete. Admittedly, I used a small amount of steel for the side walls, mainly to reinforce the corners, but that only cost a few tens of thousands of pounds!
I can recommend it to everyone!”
Takács Péter
Szeged
“I am satisfied with macrofibres because they are much easier to use and more energy efficient than concrete mesh. They do not take up so much space, they are easy to mix into the concrete and do not require any extra effort or expertise from the user. The end result is a perfectly crack-free concrete base. No cracks are visible on the finished concrete substrate.
I plan to use macro fibre again in the near future, for a garden walkway.”Fűz Márk
Szigethalom
“I used it! I didn’t have to worry about the welded mesh being trampled by the small tipper that delivered the finished concrete. It simply tamped down; all we had to do was smooth it out. With a 55m² driveway, we finished in 5 hours, the two of us. A small amount, about 0.2 m³, was left. After a month, it took me more than half an hour to chisel it out with a large chiseling machine!”
Lévai György
Miskolc
“Hi! I’ve built the base for the garden storage body. I replaced the iron reinforcement with macrofiber, which was at least 30% cheaper and eliminated the hassle of dealing with iron (I buy the iron, bring it home, and love it.) Since I have a few more projects in mind, I’m sticking with this method.”
Nyitrai Csaba
Zsombó
“The concrete is great with the macro fibre. Today we did the a “test” on it. 🙂
It was easy to work with, we did as you recommended, measured out the right amount for a concrete mixer in a plastic bottle and then used the bottle as a measure. The amount was just enough.
The mason was amazed at its simplicity and greatness. 🙂
I think he will recommend it to others from now on. The delivery was fine too.
Thank you for your help!”Petrás Zsuzsanna
Gödöllő
“It was easy to work with because you just mix it into the concrete.It cost less in time and materials than if I had used rebar and the concrete was perfect. It didn’t crack.”
Szanyi Zoltán
“We added a thicker layer to the existing terrace. I was initially worried about smoothing it, but it turned out I didn’t have to. The end result is very nice. 🙂 Macrofiber is very easy to use. Special thanks for the fast delivery.”
Lelong Szilvia
“I’ve used half of it, and I’m happy with the product. It’s easier to mix with the mixer than wrestling with the rusty concrete mesh. I applied a 15cm thick layer in all parts, whereas the mesh is only in the middle!”
Weitz András
Pápa
“It’s not the first, and certainly won’t be the last time, I’ve used macrofiber in concreting. Apart from being more cost-effective and eliminating the need for iron installation work, the concrete sets rock hard with not a hairline crack anywhere.”
Barta Szabolcs
Budapest